XGE(4) FreeBSD Kernel Interfaces Manual XGE(4)
NAME
xge - Neterion Xframe-I Ten Gigabit Ethernet driver
SYNOPSIS
xge* at pci? dev ? function ?
DESCRIPTION
The xge device driver supports the Neterion Xframe-I LR Ethernet adapter,
which uses a single mode fiber (1310nm) interface.
The Xframe supports IPv4/TCP/UDP checksumming in hardware, as well as TCP
Segmentation Offloading (TSO) and hardware VLAN handling. The driver
currently does not support the hardware VLAN feature. See ifconfig(8)
for information on how to enable TSO and hardware checksum calculation.
DIAGNOSTICS
xge%s: failed configuring endian, %llx != %llx! The Xframe could not be
turned into the correct endian operation. This is most likely a hardware
error.
xge%d: failed allocating txmem.
xge%d: failed allocating rxmem. The computer has run out of kernel
memory.
xge%d: adapter not quiescent, aborting
xge%d: ADAPTER_STATUS missing bits %s The Xframe could not be turned
into a usable state. Most likely an Xframe hardware error.
xge%d: cannot create TX DMA maps
xge%d: cannot create RX DMA maps This error is either a kernel error or
that the kernel has run out of available memory.
xge%d: bad compiler struct alignment, %d != %d The compiler did not
align the structure correctly. This is a compiler problem.
SEE ALSO
arp(4), ifmedia(4), netintro(4), pci(4), ifconfig(8)
HISTORY
The xge driver first appeared in NetBSD 3.0.
AUTHORS
The xge driver was written by Anders Magnusson <
[email protected]>.
BUGS
There should be an XGMII framework for the driver to use.
FreeBSD 14.1-RELEASE-p8 September 9, 2005 FreeBSD 14.1-RELEASE-p8