UBSA(4) FreeBSD Kernel Interfaces Manual UBSA(4)
NAME
ubsa - USB support for Belkin serial adapters
SYNOPSIS
To compile this driver into the kernel, place the following lines in your
kernel configuration file:
device usb
device ucom
device ubsa
Alternatively, to load the driver as a module at boot time, place the
following line in loader.conf(5):
ubsa_load="YES"
DESCRIPTION
The ubsa driver provides support for the USB-to-RS232 Bridge chip used by
a variety of serial adapters from Belkin and other vendors.
The device is accessed through the ucom(4) driver which makes it behave
like a tty(4).
HARDWARE
The ubsa driver supports the following adapters:
o AnyData ADU-500A EV-DO modem
o AnyData ADU-E100A (no EV-DO mode support)
o Belkin F5U103
o Belkin F5U120
o e-Tek Labs Kwik232
o GoHubs GoCOM232
o Peracom single port serial adapter
FILES
/dev/ttyU* for callin ports
/dev/ttyU*.init
/dev/ttyU*.lock corresponding callin initial-state and lock-state
devices
/dev/cuaU* for callout ports
/dev/cuaU*.init
/dev/cuaU*.lock corresponding callout initial-state and lock-state
devices
SEE ALSO
tty(4), ucom(4), usb(4)
HISTORY
The ubsa driver appeared in FreeBSD 5.0. The uplcom(4) manual page was
adopted from NetBSD by Tom Rhodes <
[email protected]> in April 2002 and
modified for the ubsa driver by Alexander Kabaev <
[email protected]> in
October 2002.
AUTHORS
The ubsa driver was written by Alexander Kabaev <
[email protected]>.
FreeBSD 14.1-RELEASE-p8 April 26, 2017 FreeBSD 14.1-RELEASE-p8