PST(4) FreeBSD Kernel Interfaces Manual PST(4)
NAME
pst - device driver for Promise Supertrak SX6000
SYNOPSIS
To compile this driver into the kernel, place the following line in your
kernel configuration file:
device pst
Alternatively, to load the driver as a module at boot time, place the
following line in loader.conf(5):
pst_load="YES"
DESCRIPTION
This driver is for the Promise Supertrak SX6000 ATA hardware RAID
controller. It supports (in hardware) RAID levels 0, 1, 0+1, 3, 5 and
JBOD on up to 6 ATA disk drives, including automatic rebuild and hotswap,
and supports signalling disk status on LEDs on Promise Superswap disk
enclosures. The Supertrak line of controllers does not support non-disk
devices.
HARDWARE
The pst driver supports the Promise Supertrak SX6000 ATA hardware RAID
controller.
NOTES
The pst driver does not support manipulating the RAID from the OS, RAIDs
need to be set up from the onboard BIOS. However, hot swap, hot spare,
and automatic rebuilds are supported without a reboot.
HISTORY
The pst driver first appeared in FreeBSD 4.7.
AUTHORS
The pst driver and man page was written by Soren Schmidt
<
[email protected]>.
FreeBSD 14.1-RELEASE-p8 December 14, 2004 FreeBSD 14.1-RELEASE-p8