HCONF(4) FreeBSD Kernel Interfaces Manual HCONF(4)
NAME
hconf - MS Windows Precision Touchpad configuration driver
SYNOPSIS
To compile this driver into the kernel, place the following lines in your
kernel configuration file:
device hconf
device hid
device hidbus
Alternatively, to load the driver as a module at boot time, place the
following line in loader.conf(5):
hconf_load="YES"
DESCRIPTION
The hconf driver provides support for generic MS Windows Precision
Touchpad configuration collection. It enables the host to configure two
different aspects of the device. One allows the host to select input
mode, and the other allows the host to be selective in what is reported.
SYSCTL VARIABLES
Next parameters are available as sysctl(8) variables. Debug parameter is
available as loader(8) tunable as well.
dev.hconf.*.input_mode
HID device input mode: 0 = mouse, 3 = touchpad.
dev.hconf.*.surface_switch
Enable / disable switch for surface: 1 = on, 0 = off.
dev.hconf.*.buttons_switch
Enable / disable switch for buttons: 1 = on, 0 = off.
hw.hid.hconf.debug
Debug output level, where 0 is debugging disabled and larger
values increase debug message verbosity. Default is 0.
SEE ALSO
hms(4), hmt(4)
HISTORY
The hconf driver first appeared in FreeBSD 13.0.
AUTHORS
The hconf driver was written by Vladimir Kondratyev <
[email protected]>.
Switch parameter support was added by Andriy Gapon <
[email protected]>.
FreeBSD 14.1-RELEASE-p8 January 18, 2021 FreeBSD 14.1-RELEASE-p8