Manual Page Result
0
Command: fwe | Section: 4 | Source: FreeBSD | File: fwe.4.gz
FWE(4) FreeBSD Kernel Interfaces Manual FWE(4)
NAME
fwe - Ethernet emulation driver for FireWire
SYNOPSIS
To compile this driver into the kernel, place the following lines in your
kernel configuration file:
device firewire
device fwe
Alternatively, to load the driver as a module at boot time, place the
following line in loader.conf(5):
if_fwe_load="YES"
DESCRIPTION
The fwe driver provides non-standard Ethernet emulation over FireWire
(IEEE 1394).
firewire(4) and fwohci(4) must be configured in the kernel as well.
This driver exploits asynchronous stream over IEEE 1394 to carry Ethernet
frames. The stream channel can be specified by the
hw.firewire.fwe.stream_ch sysctl(8).
This driver supports polling(4) as well if it is compiled with the
DEVICE_POLLING option.
SEE ALSO
arp(4), firewire(4), fwip(4), fwohci(4), netintro(4), ng_ether(4),
polling(4), ifconfig(8), kldload(8), sysctl(8)
HISTORY
The fwe device driver first appeared in FreeBSD 5.0.
AUTHORS
The fwe driver and this manual page were written by Hidetoshi Shimokawa.
BUGS
This driver emulates Ethernet in a very adhoc way and it does not reserve
a stream channel using an isochronous manager. Note that this driver
uses a protocol which is very different from RFC 2734 (IPv4 over IEEE
1394).
FreeBSD 14.1-RELEASE-p8 July 16, 2005 FreeBSD 14.1-RELEASE-p8